Power Up the Machine
|
|
|
|
Model |
[•] Hylo™ |
|
|
Category |
[•] Installation |
[ ] Operation |
[ ] Maintenance |
Summary
The procedure that follows gives instructions on how to power ON the AON3D Hylo™ machine.
Estimated time: 15 minutes
None required.
None required.
Personal Protective Equipment
Qty |
Description |
Minimum Specification |
1 |
Safety Eyewear |
ANSI/ISEA Z87.1 |
Install Compressed Air Supply
- Refer to the Power Requirements for compressor sizing information.
- Insert the male connector into the 3/8 in NPT fitting (1) at the back of the machine.
Install Power Cords and Power-Up the Machine
- Connect power to the machine (2) from the local supply disconnecting device. Refer to the Power Requirements page.
- Turn the main disconnect button (3) in the ON (1) position.
- Turn the machine main power ON at the ON/OFF switch (4) found on the front panel.
- Release the E-stop button (5).
Checklist
- Is the machine powered ON?
- Is the vacuum circuit powered ON?
- Do the cold plenum enclosure fans run?
- Are the build chamber lights powered ON?
- Is the Graphical User Interface (GUI) powered ON and loaded with the AON3D logo?
Reach out to our Customer Success team at help@aon3d.com if there are any questions in regards to the installation procedure.