The customer is responsible to make sure that all necessary electrical work is done by a licensed electrical contractor in accordance to their local laws and/or regulations.
| Specification | Value |
|---|---|
| Voltage | 208-240 VAC, 1-phase (L1, L2/N) |
| Frequency | 50/60 Hz |
| Current | 50.0 Amp |
| Power Cord | 3.6 m (144 in) cable, bare wires (integrated) |
There is no plug for the Hylo™. The integrated power cable for the Hylo™ ends with bare wires.
AON3D recommends a 50 A circuit breaker to satisfy both the overcurrent protection and supply disconnecting requirements below.
Warning - Required Disconnect Means
A supply disconnecting device shall be provided for the Hylo™ machine, for example:
• a switch-disconnector, with or without fuses, in accordance with IEC 60947-3, utilization
category AC-23B or DC-23B.
• control and protective switching device suitable for isolation, in accordance with
IEC 60947-6-2.
• a circuit-breaker suitable for isolation in accordance with IEC 60947-2.
• any other switching device in accordance with an IEC product standard for that device and
which meets the isolation requirements and the appropriate utilization category and/or
specified endurance requirements defined in the product standard.
Warning - Required Overcurrent Protection
An overcurrent protection device must be provided for the Hylo™ machine, either a fused device or a circuit breaker.
The Hylo™ is equipped with a 3/8″ NPT female inlet and requires a compressed air source.
AON3D recommends sizing the air compressor as follows: