|Model||[•] AON M2+ (CE)||[•] AON M2+ (R-NZ)||[•] AON M2+||[•] AON-M2 2020||[•] AON-M2|
|Category||[•] Installation||[ ] Operation||[ ] Maintenance|
The procedure that follows gives instructions on how to install the Extruder Pro assemblies onto the AON3D machine.
The advantages of the Extruder Pro assemblies are as follows:
Estimated time: 60 minutes
AON3D recommends using the Extruder Pro assemblies in combination with the tungsten carbide nozzles for composite-filled filament.
The Extruder Pro assemblies require the filament feed path upgrade to be installed onto the machine.
The AON M2+ includes the feed path upgrade kit as standard equipment.
AON3D offers a feed path upgrade kit (part number K-0999-012) for the AON-M2 2020 and AON-M2 models.
|1||Hex Key||2.5 mm|
|1||Hex Key||2 mm|
AON3D the Extruder Pro assemblies must be installed on the T0 and T1 toolheads as this configuration requires a modification of the extruder motor step-per-mm value.
|1||K-000020||Extruder Pro Kit|
|2||. C-000892||Extruder Pro Gearbox, Screws and Pushfit|
|2||. HW-SHCS-M3-50||Black-Oxide Alloy Steel Socket Head Screw, M3 x 0.5 mm Thread, 50 mm Long|
|2||. C-000616||Partially Threaded Steel Stud M3 x 10mm Long|
|2||. HW-SHCS-M3-8-SS||18-8 Stainless Steel Socket Head Screw, M3 x 0.5 mm Thread|
Reach out to our Customer Success team at email@example.com for genuine AON3D replacement part(s) inquiries.
|1||Safety Eyewear||ANSI/ISEA Z87.1|
|1||Safety Footwear||EN ISO 20345 or ASTM F2413|
|A/R||Nitrile Gloves||ISO 2859-1 or ASTM D6319|
The extruder step-per-mm value must be re-entered if the following happens:
• Machine firmware is updated.
• Machine SD card is replaced.
• Machine EEPROM is reset with the
• Machine is Reset to Factory Default using the
Purge button on the GUI.
This procedure applies for the AON M2+ (CE), AON M2+ (R-NZ) and AON M2+ machines with application version starting at version 45dccb0.
SET_EXTRUDER_MODEL MODEL=procommand and select enter. This will change the value of the extruder motor steps (steps-per-mm) to extruder pro value.
SAVE_CONFIGcommand and select enter. This will save the new configuration to the EEPROM.
This procedure applies for machines with application version v2022.07.04.21.14.
M92 E684command and select enter. This will set the value of the extruder motor steps (steps-per-mm) to 684 steps-per-mm.
M500command and select enter. This will save the new configuration to the EEPROM.
M503to report current configuration.
Steps per unit (step/mm): M92 X40.0000 Y40.0000 Z400.0000 E684.0000
Wait until all machine components are at room temperature before you continue. Some machine components can be hot if the machine was recently used. Failure to do so can cause injuries.
There are more fasteners in the provided kit than required to account for different machine models.