|Model||[ ] AON M2+ (CE)||[ ] AON M2+ (R-NZ)||[ ] AON M2+||[•] AON-M2 2020||[ ] AON-M2|
|Category||[ ] Preventive||[•] Corrective|
The procedure that follows gives the instructions on how replace the build chamber halogen light bulbs.
Estimated time: 30 minutes
|1||Pliers||90 degree angle|
|A/R||BDC7A7BA||WGB-3 blue halogen Bulb G5.3, 230V, 50W (Colour 5,000K)|
Reach out to our Customer Success team at firstname.lastname@example.org for genuine AON3D replacement part(s).
|1||Safety Eyewear||ANSI/ISEA Z87.1|
|A/R||Nitrile Gloves||ISO 2859-1 or ASTM D6319|
Dangerous voltages continue to be found in the electrical panel when the ON/OFF switch is set to OFF. Disconnect the main power cord from the machine while maintenance is done. Failure to do so can cause electric shock.
Wait until all machine components are at room temperature before you continue. Some machine components can be hot if the machine was recently used. Failure to do so can cause injuries.
Be careful not to break the glass base of the halogen light bulb. The halogen light bulbs can shatter if not carefully handled.
Do not remove the halogen light bulb housing when the halogen light bulbs are replaced. Removal of the halogen light bulb housing can cause personal injury and/or cause damage to the machine component(s).
Do the steps that follow to remove the burnt halogen light bulb(s) from the halogen light bulb housing:
Do not touch the halogen light bulb(s) with your bare hands. The solvents found on our skin can cause damage to the halogen bulb(s).
AON3D recommends that the Automatic Light Shutoff Feature is enabled to help improve the lifespan of the halogen light bulbs. Refer to Automatic Light Shutoff Feature.