|Model||[•] AON M2+ (CE)||[•] AON M2+ (R-NZ)||[•] AON M2+||[•] AON-M2 2020||[•] AON-M2|
|Category||[ ] Preventive||[•] Corrective|
The procedure that follows gives the instructions on how to replace the two heater block assemblies.
Estimated time: 15 minutes
|2||M2-SUB-HOT-END-HTR-BLK-0.2-R01||M2 Hot End HTR BLK Sub-Assy - 0.2 mm|
|2||M2-SUB-HOT-END-HTR-BLK-0.25-R01||M2 Hot End HTR BLK Sub-Assy - 0.25 mm|
|2||M2-SUB-HOT-END-HTR-BLK-0.3-R01||M2 Hot End HTR BLK Sub-Assy - 0.3 mm|
|2||M2-SUB-HOT-END-HTR-BLK-0.4-R01||M2 Hot End HTR BLK Sub-Assy - 0.4 mm|
|2||M2-SUB-HOT-END-HTR-BLK-0.8-R01||M2 Hot End HTR BLK Sub-Assy - 0.8 mm|
|2||M2-SUB-HOT-END-HTR-BLK-1.0-R01||M2 Hot End HTR BLK Sub-Assy - 1.0 mm|
|2||M2-SUB-HOT-END-HTR-BLK-1.2-R01||M2 Hot End HTR BLK Sub-Assy - 1.2 mm|
Reach out to our Customer Success team at email@example.com for genuine AON3D replacement part(s).
|1||Safety Eyewear||ANSI/ISEA Z87.1|
Dangerous voltages continue to be found in the electrical panel when the ON/OFF switch is set to OFF. Disconnect the main power cord from the machine while maintenance is done. Failure to do so can cause electric shock.
Wait until all machine components are at room temperature before you continue. Some machine components can be hot if the machine was recently used. Failure to do so can cause injuries.
There is a small PTFE tube that is installed in between the bottom of the extruder through the heat sink into the top of the heat break. This is a crucial piece of the filament feed path. The small PTFE tube can stick in the heat break and come out when removed from the heater block assembly. Be careful not to lose it, and make sure to replace it when you install the new assembly.
Do not bend the heat break when the heater block assembly is removed. Failure to do so can cause damage to the heat break.
Do not apply any lubricants to the heat break threads. The heat break must be installed dry.
Do not bend the heat break when the heater block assembly is installed. Failure to do so can cause damage to the heat break.
Do not use the Vise-Grip™ to install and/or tighten the heater block assembly. The use of Vise-Grips™ can cause damage to machine component(s).