Graphical User Interface

Summary

This section will help you get familiarized with the Graphical User Interface (GUI) of the AON3D machine.

GUI Overview

GUI Overview

  1. Status Bar
  2. Home Page
  3. Control Page
  4. Temp Page
  5. Terminal Page
  6. Files Page
  7. Settings Page

Status Bar

GUI Overview

  1. Machine Status
  2. Door Open Indicator
  3. Time

Machine Status

Shows the current status of the machine. The machine can have the statuses that follow:

  • Pre-processing: Shows that the machine is pre-processing a recently started print job.
  • Printing: Shows that the machine is printing.
  • Resuming: Shows that the machine is resuming a previously paused print job.
  • Pausing: Shows that the machine has received a pause command.
  • Paused: Shows that the current print job is paused and waiting for the user to resume it.
  • Filament Ran Out: Shows that the machine has detected that the filament has run out.
  • Stopping Print: Shows that the machine has received a stop command.
  • Parking Tools: Shows that the machine is moving the toolheads to the parked position.
  • Aborting: Shows that the machine has received quick stop command that forces the current print to stop.
  • Inactive (Check E-Stop): Shows that the E-Stop has been pressed.
  • Updating firmware. Do not turn off the machine.: Shows that a firmware updates is in progress.
  • Idle: Shows that the machine is ready to start a print job.
  • Busy: Shows that the machine is executing a command.

Door Open Indicator

The door open indicator is only applicable to the AON M2+ (CE) machines.

The door open indicator is displayed when the door of the machine is open. When the door is closed and locked, this indicator is not shown.

Time

Shows the current time of the machine.

The time is set when the machine can connect to the internet and communicate with the NTP server. The time zone is determined by the geolocation of the requesting IP address.

Make sure that the network firewall is configured to allow the NTP protocol. Refer to Firewall Information.

Screensaver

The screensaver is shown when no input is made for a period of five minutes. Touch the screen to stop the screensaver. GUI Overview

Table of Contents


Last modified: September 1, 2022