Toolhead Heater Timeout Feature

The AON-M2 and AON-M2 2020 toolhead heaters automatically turn OFF after a period of inactivity while there is no active print job. This feature increases the safety of an unattended machine. It can be used to prolong the life of your heater block assemblies and prevent material breakdown.

The heater timeout feature is set to 30 minutes by default. This feature can be set from the machine touchscreen or browser interface.

Navigate to the Settings page and then go to the General tab. Set the Heater Timeout feature by entering a timeout value in minutes. Tap “Save” at the bottom to save your feature selection.

Entering a timeout value of 0 minutes disables the Heater Timeout feature.

Heater Timeout Feature

Last modified: November 24, 2020